Down anyone know of it works with belt printers? I had it, but it kept restarting some prints that were fine and never detected a failure :(

I read it as “sandpaper i made in a blender” and thought that its somehow recycled sandpaper

At the beginning I had several issues. If I remember correctly first I has to level the front part, then mark the distance with a wedge and have that same distance on the back.

For this it is important that when you’re adjusting the Y0 check on both edges and in the middle. It should be the same height overall

Once it’s leveled you need to adjust the Y offset until it sticks, for this you can print a zigzag pattern and it should stick equally well everywhere.

I remember I had saved some videos that explain that let me find them. Also the discord community is helpful for this particular printer

Yes, it looks better than I expected. I will seal it later to prevent bacterial growth as someone suggested here

Had to make a second version because the one on the post was too fragile. It was bending with just the glass. The new one looks like this