The available screen resolution is the screen height minus 48 pixels.

How does this help woth fingerprinting?

Hah, yea. 100% adding on 😀 Hopefully tomorrow is a brighter day!

Or open an editor?

It can. All standard spec NFC: https://specs.openprinttag.org/#/nfc_data_format

So any USB or GPIO reader would work. This will be in Klipper quick I bet.

Also, it’s loud by default. I immediately switched the two fans underneath for noctuas, which helper a ton. Now the only thing I hear is the loud “quacking” of the auxiliary feeder, for which there are software mods to silence that I just haven’t done yet.

I’ve been pretty happy with it. PLA is pretty spot on, and I need to scale ABS by 100.4% for large parts to cover shrinkage but I do that with other printers, too.

Is it as dimensionally accurate as the Voron V0.2 above it in that picture? No. But is it really close? Yes. If your tollerences are a mm, you’ll be fine. I’d only worry if the tolerences were less thsn say .2-.4 mm. Just remember some materials shrink as they cool, no matter what printer you use, so calibration is key for them.

Given you’re thinking chamber heater, you probably already know how to handle that, though.