Well I can certainly send you links to the brilliant work of others that inspired me. 🤣
This is the base slider I use for the glass, with these risers for the AMS and this addon for an LED strip.
The LED strip I purchased is this one. I did have to use a dremel to widen the wire way on the slider/riser system, and (of course) had to cut off a good length of excess LED, but there was a very convenient cut point that means most of the back edge isn’t covered by light, but it still works great.
Pass around schematics on flash drives like its cod3 in your computer class in high school.
Why would you infest your fellow classmates with that Treyarch nonsense? Give them CoD2 or CoD4MW like a good Infinity Ward fan.
(This take on Treyarch/Infinity Ward brought to you by the year 2008 or so, when I last cared about it. 😅)
In my class it was Unreal Tournament. Or a version of the open source Cube 2 where I had replaced all gun models with fists and rockets with couches so our teacher couldn’t complain about us shooting one another. 🤣
Oh those look great!
I have a COB LED strip plugged into a USB port on the same power strip as the printer, installed on a riser/slider system for the glass top and AMS, with the wire running through said riser.
At first I was frustrated that I wouldn’t be able to use the printer’s light control with this, but it has actually turned out pretty nice since the lights stay on for maintenance work and nozzle changes, when the printer is turned off.
I like your solution though!
Oh I totally get it, and probably would’ve gone that route if my DIY skill level was higher. My benefit of maintenance lighting is a lucky accident. 🤣